2000 BMW Serie 3 problems

• M57D30, first-generation 3.0 litres (177-193 hp, 1998-2006 depending on application)

  177–193 hp · M57D30

  A specialist workshop points out that the versions with an automatic gearbox have the swirl flaps that are prone to breaking, while the E53 X5 3.0d (across its whole production run) and the manual versions of the first 330d and 530d are free of them.^[3]

  With caution

Faults that affect 2000 cars

• Critical severityFrequency: CommonIntakeBroken intake swirl flapsYes: most automatic M57 and M57TU engines (330d, 530d, 535d, 730d, X3 3.0d and so on) have six metal flaps in the intake manifold that can seize, come loose and wreck a cylinder. The E53 X5 3.0d and the manual gearboxes of the first 330d/530d are free of them, according to a specialist workshop.
• High severityFrequency: CommonLubricationCrankcase ventilation (PCV) valve failureThe valve that separates oil from the crankcase gases (PCV) degrades over time, especially after 120,000-150,000 km, and can cause oil consumption, bluish smoke and a rough idle and, if ignored, foul the turbo, the EGR or the particulate filter.Appears at around 120,000 km
• Medium severityFrequency: OccasionalCylinder head and blockCracked exhaust manifoldThe M57 exhaust manifold can crack, causing loss of power, an unstable idle and a smell of exhaust fumes in the cabin; the recommended repair is to replace it with a cast one.
• Medium severityFrequency: OccasionalOtherCrankshaft pulley vibration damper failureThe M57 crankshaft vibration damper (pulley) can fail with use, warning with abnormal noises and knocking at the front of the engine before it breaks completely.
• Low severityFrequency: OccasionalIntakeFaulty air flow meter on the BMW M57 (loss of power)The air flow meter is a known fault on six-cylinder M57 diesels: over time it loses accuracy and the car pulls less. It is a cheap repair compared with the turbo or injection.Repair (garage): €100–€300

• M54B22, 2.2 litres (168-170 hp)

  170 hp · M54B22

  A long-lived engine if maintained, but expect to renew the cooling system and the CCV if there are no invoices.^[6][7][8]

  With caution

• M54B25, 2.5 litres (189-192 hp)

  192 hp · M54B25

  A long-lived engine if maintained, but expect to renew the cooling system and the CCV if there are no invoices.^[6][7][8]

  With caution

• M54B30, 3.0 litres (228-235 hp)

  231–235 hp · M54B30

  A long-lived engine if maintained, but expect to renew the cooling system and the CCV if there are no invoices.^[6][7][8]

  With caution

Faults that affect 2000 cars

• High severityFrequency: CommonCoolingThermostat and water pump failureThe M54's thermostat, housing and water pump contain plastics that become brittle and fail. If left unattended, overheating can warp the aluminium cylinder head. It is advisable to replace them together.Appears at around 129,000 km
• High severityFrequency: CommonCoolingCracked expansion tank and coolant leakThe plastic expansion tank degrades over the years and eventually cracks. It is cheap compared with the cost of overheating an M52/M54, and age matters more than mileage.
• Medium severityFrequency: CommonLubricationCracked crankcase ventilation valve (CCV) and oil consumptionThe M54's CCV valve (oil separator) is made of plastic and cracks with age: oil then gets into the intake, consumption rises and a rough idle and smoke appear. It is the engine's most frequently cited weak point.Appears at around 96,000 km
• Medium severityFrequency: CommonLubricationOil leak from the valve cover gasketThe M54's valve cover is made of plastic and, over the years, warps and stops sealing: oil leaks, a burning smell, oily spark plugs and misfires appear. It is replaced together with the gasket.
• Medium severityFrequency: OccasionalOtherWorn VANOS O-ringsThe seals in the VANOS (variable valve timing) system harden with heat and synthetic oil: the engine loses power below 3,000 rpm and the idle becomes rough. It is fixed with a seal kit.Appears at around 129,000 km

• M47D20 116-136 hp (1998-2001)

  116–136 hp · M47D20

  It predates the introduction of the swirl flaps, the M47's best-documented problem, and we have not found a serious fault specifically documented for this first rotary-pump version; even so, given its age, the turbo and injectors should be checked as on any diesel more than 20 years old.^[9][10]

  Buy

Faults that affect 2000 cars

• High severityFrequency: CommonTurboLoss of power and turbo faultsThe M47's turbo does not usually fail suddenly, but it loses power gradually as carbon builds up in the variable geometry; the 150 hp variant built between September 2001 and November 2003 also accounts for turbo faults documented by specialist workshops.
• Medium severityFrequency: CommonClutchDual-mass flywheel wear (manual gearbox versions)On BMWs with the M47 engine and a manual gearbox, the dual-mass flywheel can wear with mileage, especially with a lot of urban use or long spells in high gears at low revs; typical symptoms are vibrations, a metallic rattle at idle and jerking when pulling away.Appears at around 150,000 km
• Critical severityFrequency: RareOtherOil leak from the brake vacuum pumpA BMW specialist workshop documents that the seals of the M47's vacuum pump, which generates the vacuum needed for brake assistance because a diesel does not produce it naturally, can wear and let oil through, which can end up stiffening the brake pedal.
• Low severityFrequency: OccasionalIntakeFaulty air flow meter on the BMW M47 (loss of power)On the 2.0 M47 diesel the air flow meter appears among parts that can fail with age and cause loss of power or judder. It is fixed by replacing the sensor; other causes must be ruled out first.Repair (garage): €100–€300

• Critical severityFrequency: OccasionalAirbags and safetyCampaigns over the Takata gas generators in the front and passenger airbagsYes: the 3 Series E46 is included in several successive BMW campaigns (between 2014 and 2026) over the Takata gas generators in the driver and passenger airbags, which can degrade over the years and throw metal fragments when they deploy. The most recent ones cover cars built between 1998 and 2006.Repair: €0
• High severityFrequency: OccasionalSuspensionCracks in the rear subframe mountingsOn the oldest cars (before March 2000, according to gebrauchtwagenberater.de), cracks can appear at the points where the rear subframe is mounted to the body, especially on six-cylinder versions; BMW offered a preventive resin sealing as an alternative to a full repair.
• Medium severityFrequency: CommonSuspensionWear of the suspension bushes, ball joints and bushingsWith mileage, the suspension arm bushes, ball joints and bushings wear and cause vibrations, noises and less precise steering; fiches-auto.fr describes it as very recurrent between 60,000 and 180,000 km.Repair (garage): €300–€600Appears at around 60,000 km
• Medium severityFrequency: CommonElectrical systemCentral locking and immobiliser failure due to worn relaysThe central locking can become intermittent or stop responding to the remote, and the immobiliser can fail sporadically when starting; gebrauchtwagenberater.de attributes both faults to wear in the relays of the control modules, and fiches-auto.fr records numerous testimonies of unreliable locking.
• Low severityFrequency: Very frequentElectrical systemBreakage of the plastic tabs in the electric window regulator mechanismIt is one of the most frequently cited non-engine faults of the E46: a small plastic tab in the window regulator mechanism breaks with use and the window stops going up or drops on its own, on any of the four doors. fiches-auto.fr records more than 80 testimonies of this fault.Repair (garage): €150–€250Appears at around 140,000 km