Skip to content
MotorFiable

Electrical system and control unitsGeneric OBD-II codeUrgency: Garage soon

Code U0001: high-speed CAN bus fault

U0001 means: high-speed CAN communication bus.[1][2] According to Carista, it indicates a general fault on the high-speed CAN bus, the car's fastest data network for engine and stability messages: it is shorted or open and the messages arrive corrupted.[1]

System
Electrical system and control units
Urgency
Garage soon
You can drive carefully, but book a garage appointment as soon as possible
Possible causes
3
sorted from most to least likely
Type
Generic
The same on all makes

4 sourcesHow we work

What code U0001 means

According to Carista, it indicates a general fault on the high-speed CAN bus, the car's fastest data network for engine and stability messages: it is shorted or open and the messages arrive corrupted.[1]

The high-speed bus is a twisted pair terminated with a 120 Ω resistor at each end, so with the ignition off and the modules asleep, about 60 Ω is measured between CAN-H and CAN-L.[1][3]

Original definition (SAE J2012): High Speed CAN Communication Bus[1][2]

Causes of U0001

From most to least likely, according to the sources.

  1. 1CAN-H or CAN-L wire shorted to ground, to positive or to each other.[1]
  2. 2Broken wire, faulty splice or damaged terminating resistor in the harness.[1]
  3. 3A single failed module dragging down the whole bus; it is identified by disconnecting modules one at a time.[1]

Symptoms

How to diagnose U0001

In order: from the most likely and cheapest to check to the most expensive.

  1. 1Read the U codes from all the modules to see which nodes are still communicating.[1]
  2. 2Use a multimeter to measure CAN-H and CAN-L against ground and against each other; between H and L you should see about 60 Ω with the ignition off and the modules asleep.[1][3]
  3. 3Disconnect the suspect modules one at a time to find the one that is blocking the bus.[1]
  4. 4Repair the wiring or replace the failed module.[1]

Can I keep driving with U0001?

Garage soon

Carista cites limp mode and a possible inability to start, so do not put off the check; the severity depends on which modules lose communication.[1]

Parts related to code U0001

The parts that most often cause this code. The code points to the circuit, not always the part: diagnose before you buy.

Affiliate links: if you buy from these shops, MotorFiable may receive a commission at no cost to you. Check compatibility against the registration plate or VIN before ordering. More information

Documented faults related to U0001

Known faults of specific engines and cars, with their repair cost, the affected years and their sources.

Control units and comfort electronics (BSI, SAM...): the most serious faults by engine and car

All faults with the control units (51)

Wiring, connectors and short circuits: the most serious faults by engine and car

All faults with the electrical wiring (160)

12 V battery: the most serious faults by engine and car

All faults with the 12 V battery (98)

Frequently asked questions

What does code U0001 mean?

A general fault on the high-speed CAN bus, the network over which the engine and stability modules communicate.[1][2]

How much does it cost to fix?

Carista estimates between £100 and £700 in the UK; in Spain the cost depends on whether it is wiring or a module and we have no source of our own.[1]

Can I drive with U0001?

There may be limp mode or starting failures, according to Carista; the sensible thing is to go to a garage as soon as possible.[1]

How is the cause located?

By measuring CAN-H and CAN-L (about 60 Ω between them), reading the codes from all the modules and disconnecting them one at a time.[1][3]

Will I pass the MOT with code U0001?

If the code has switched on the engine warning light, no: with that light on, the inspection records a serious defect, and on Euro 5 and Euro 6 cars the ITV (Spain's roadworthiness inspection, similar to the MOT) also reads the OBD diagnostic system. Repair the fault before you go; clearing the code just before the inspection does not help either, because it counts as a serious defect.[4]

Not sure what is wrong with your car? Describe what you notice in the symptom diagnosis or see all fault codes.

Sources

Every fact on this page links to its source. If you find an error, let us know.

  1. U0001 Code: High-Speed CAN Bus faultCarista · Technical documentation · consulted 29 October 2026
  2. U0001 OBD Trouble CodeDTCSearch.com (OBD Solutions) · Technical documentation · consulted 29 October 2026
  3. CAN busWikipedia · Other source · consulted 29 October 2026
  4. Desmontando mitos: ¿puede pasar mi coche la ITV con el testigo de «avería motor» encendido?Diariomotor · Motoring press · published 8 March 2021 · consulted 2 October 2026 · in Spanish